Command Line Interface
5691553-KDU 137 365 Uen D 2006-06-16
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (section 7.5.16 on page 566)
whichboot (section 7.5.17 on page 567)
Line Commands
The onboard configuration program can be accessed by attaching a VT100
compatible device to the ECN330’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (a virtual terminal).
Table 42 Line Commands
Console(config)#boot system config: startup
Console(config)#
Command Function Mode Page
line Identifies a specific line for configuration and starts the
line configuration mode
GC 570
login Enables password checking at login LC 571
password Specifies a password on a line LC 573
timeout
login
response
Sets the interval that the system waits for a login attempt LC
exec-timeout Sets the interval that the command interpreter waits until
user input is detected
LC 575
To Next Page
Loading...
