Ericsson ECN330 - Show Ip Dvmrp Route

Command Line Interface
1118 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
This command displays the global DVMRP settings described in the
preceding pages:
• Admin Status, router dvmrp, (section 7.27.3 on page 1108)
• probe-interval (section 7.27.4 on page 1110)
• nbr-timeout (section 7.27.5 on page 1111)
• flash-update-interval (section 7.27.7 on page 1112)
• prune-lifetime (section 7.27.8 on page 1113)
• report-interval (section 7.27.6 on page 1112
• default-gateway (section 7.27.9 on page 1114)
• ip dvmrp metric (section 7.27.11 on page 1116)
Example
The default settings are shown in the following example:
7.27.14 show ip dvmrp route
This command displays all entries in the DVMRP routing table.
Command Mode
Normal Exec, Privileged Exec
Console#show route dvmrp
Admin Status : enable
Probe Interval : 10
Nbr expire : 35
Minimum Flash Update Interval : 5
prune lifetime : 7200
route report : 60
Default Gateway : 0.0.0.0
Metric of Default Gateway : 1
Console#