Ericsson ECN330 - Secure Shell Commands

Command Line Interface
6551553-KDU 137 365 Uen D 2006-06-16
Default Setting
Server: Enabled
Server Port: 23
Command Mode
Global Configuration
Example
Secure Shell Commands
This section describes the commands used to configure the SSH server. Note
that an SSH client also needs to be installed on the management station to
access the ECN330-switch for management using the SSH protocol.
Note: The ECN330-switch supports both SSH Version 1.5 and 2.0 clients.
Table 62 Secure Shell Commands
Console(config)#ip telnet server
Console(config)#ip telnet port 123
Console(config)#
Command Function Mode Page
ip ssh server Enables the SSH server on the ECN330-switch GC 658
ip ssh timeout Specifies the authentication timeout for the SSH
server
GC 659
ip ssh
authentication-
retries
Specifies the number of retries allowed by a client GC 660
ip ssh server-
key size
Sets the SSH server key size GC 661