Command Line Interface
950 1553-KDU 137 365 Uen D 2006-06-16
7.21.13 ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
[no] ip igmp snooping vlan <vlan-id> mrouter <interface>
• vlan-id - VLAN ID (Range: 1-4094)
• interface
• ethernet <unit>/<port>
• unit - This is device 1.
• port - Physical port number on the ECN330-switch.
(Range: 1-27)
• port-channel <channel-id> - The assigned number of an
aggregated link (Range: 1-13)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on network connections, IGMP snooping may not always be able
to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router or switch connected over the network to an interface (port
or trunk) on the ECN330-switch, that interface can be manually configured
to join all the current multicast groups.
To Next Page
Loading...
