Ericsson ECN330 - Telnet Server Commands

Command Line Interface
654 1553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
ip http secure-server (section 7.7.17 on page 651)
Telnet Server Commands
This section describes commands used to configure Telnet management
access to the ECN330-switch.
Table 61 Telnet Server Commands
7.7.19 ip telnet server
This command allows this device to be monitored or configured from Telnet. It
also specifies the TCP port number used by the Telnet interface. Use the no
form without the port keyword to disable this function. Use the no from with the
port keyword to use the default port.
Syntax
ip telnet server <port port-number>
no telnet server <port>
• port - The TCP port number used by the Telnet interface.
• port-number - The TCP port to be used by the browser interface.
(Range: 1-65535)
Console(config)#ip http secure-port 1000
Console(config)#
Command Function Mode Page
ip telnet
server
Allows the ECN330-switch to be monitored or
configured from Telnet; also specifies the port to be
used by the Telnet interface
GC 654