Ericsson ECN330 - Show Ip Mroute

Command Line Interface
11051553-KDU 137 365 Uen D 2006-06-16
page 1115), ip pim dense-mode (section 7.27.18 on page 1124) or ip
pim sparse-mode (section 7.27.39 on page 1154) commands.
Example
7.27.2 show ip mroute
This command displays the IP multicast routing table.
Syntax
show ip mroute [<group-address> <source>] [summary]
• group-address - An IP multicast group address with subscribers
directly attached or downstream from this router.
• source - The IP subnetwork at the root of the multicast delivery
tree. This subnetwork contains a known multicast source.
• summary - Displays summary information for each entry in the IP
multicast routing table.
Command Mode
Privileged Exec
Command Usage
This command displays information for multicast routing. If no optional
parameters are selected, detailed information for each entry in the multicast
address table is displayed. If a multicast group and source pair are selected,
detailed information is displayed only for the specified entry. If the summary
option is selected, an abbreviated list of information for each entry is
displayed on a single line.
Console(config)#ip multicast-routing
Console(config)#