Configuring the ECN330-switch
2271553-KDU 137 365 Uen D 2006-06-16
6.9 Address Table Settings
Switches store the addresses for all known devices. This information is used to
pass traffic directly between the inbound and outbound ports. All the addresses
learned by monitoring traffic are stored in the dynamic address table. Static
addresses that are bound to a specific port can also be manually configured.
6.9.1 Setting Static Addresses
A static address can be assigned to a specific interface on the ECN330-switch.
Static addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be ignored
and will not be written to the address table.
Command Attributes
• Current Static Address Table – Lists all the static addresses.
• Interface – Port or trunk associated with the device assigned a static
address.
• MAC Address – Physical address of a device mapped to this interface.
• VLAN – ID of configured VLAN (1-4094).
The following parameter is displayed in the web interface only.
• Static Address Counts – The number of manually configured
addresses.
To Next Page
Loading...
