Configuring the ECN330-switch
226 1553-KDU 137 365 Uen D 2006-06-16
demanded does not exceed the ECN330 or port power budget.
(Default: Enabled)
• Priority – Sets the power priority for the port. (Options: low, high, or
critical; Default: low)
• Power Allocation – Sets the power budget for the port.
(Range: 3000- 24700 milliwatts; Default: 24700 milliwatts)
Note: The maximum power allocation that configured is 24700 milliwatts.
However, the maximum guaranteed power that can be delivered to any port is
only 23100 miliwatts.
Web – Click PoE, Power Port Configuration. Enable PoE power on selected
ports, set the priority and the power budget, and then click Apply.
Figure 87 Configuring Port PoE Power
CLI – This example sets the PoE power budget for port 1 to 8 watts, the priority
to high (2), and then enables the power.
Console(config)#interface ethernet 1/1
Console(config-if)#power inline maximum allocation 13000
Console(config-if)#power inline priority 2
Console(config-if)#power inline auto
Console(config-if)#
To Next Page
Loading...
