Command Line Interface
800 1553-KDU 137 365 Uen D 2006-06-16
7.15.4 spanning-tree hello-time
This command configures the spanning tree bridge hello time globally for the
ECN330-switch. Use the no form to restore the default.
Syntax
spanning-tree hello-time <time>
no spanning-tree hello-time
time - Time in seconds, (Range: 1 - 10 seconds).
The minimum value is calculated as (max-age / 2) - 1, though never
greater than 10.
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
This command sets the time interval (in seconds) at which the root device
transmits a configuration message.
Example
Related Commands
spanning-tree forward-time (section 7.15.3 on page 799)
spanning-tree max-age (section 7.15.5 on page 801)
Console(config)#spanning-tree hello-time 5
Console(config)#
To Next Page
Loading...
