Ericsson ECN330 - Switchport Allowed Vlan

Command Line Interface
8611553-KDU 137 365 Uen D 2006-06-16
• If acceptable frame types is set to all or switchport mode is set to
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
Example
The following example shows how to set the PVID for port 1 to VLAN 3:
7.17.10 switchport allowed vlan
This command configures VLAN groups on the selected interface. Use the no
form to restore the default.
Syntax
switchport allowed vlan {add <vlan-list> [tagged |
untagged] | remove <vlan-list>}
no switchport allowed vlan
• add <vlan-list> - List of VLAN identifiers to add.
• remove <vlan-list> - List of VLAN identifiers to remove.
• vlan-list - Separate nonconsecutive VLAN identifiers with a
comma and no spaces; use a hyphen to designate a range of IDs.
Do not enter leading zeros. (Range: 1-4094).
Default Setting
All ports are assigned to VLAN 247 (untagged) and 248 (tagged) by default.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#