Ericsson ECN330 - Boot System

Command Line Interface
568 1553-KDU 137 365 Uen D 2006-06-16
Example
This example shows the information displayed by the whichboot command.
See the table under the dir command for a description of the file information
displayed by this command.
7.5.18 boot system
This command specifies the file or image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: <filename>
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM
• config *- Configuration file
• opcode* - Run-time operation code
• filename - Name of the configuration file or image name.
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Console#whichboot
File name File type Startup Size (byte)
-------------------------------- -------------- ------- -----------
Unit1:
CXC_132_8903_V1.1.bix Boot-Rom Image Y 1247116
CXC_132_8902_V3.15.bix Operation Code Y 5130696
startup1.cfg Config File Y 6821
Console#