Command Line Interface
11071553-KDU 137 365 Uen D 2006-06-16
This example lists all entries in the multicast table in summary form:
DVMRP Multicast Routing Commands
This section describes commands used to configure DVMRP dynamic multicast
routing on the ECN330-switch.
Table 148 DVMRP Multicast Routing Commands
Console#show ip mroute summary
IP Multicast Forwarding is enabled.
IP Multicast Routing Table (Summary)
Flags: P - Prune UP
Group Source Source Mask Interface Owner Flags
--------------- --------------- --------------- ---------- ------- ------
224.1.1.1 10.1.0.0 255.255.0.0 vlan1 DVMRP P
224.2.2.2 10.1.0.0 255.255.0.0 vlan1 DVMRP --
Console#
Command Function Mode Page
router dvmrp Enables DVMRP and enters router configuration
mode
GC 1108
probe-interval Sets the interval for sending neighbor probe
messages
RC 1110
nbr-timeout Sets the delay before declaring an attached
neighbor router down
RC 1111
report-interval Sets the interval for propagating the complete set
of routing tables to other neighbor routers
RC 1112
flash-update-
interval
Sets the interval for sending updates about
changes to network topology
RC 1112
prune-lifetime Defines how long a prune state remains in effect
for a source-routed multicast tree
RC 1113
To Next Page
Loading...
