Command Line Interface
824 1553-KDU 137 365 Uen D 2006-06-16
7.16 Ethernet Automatic Protection Switching Commands
This section describes commands used to configure EAPS.
Table 86 EAPS Commands
Configuration Guidelines for EAPS
1. Create or delete an EAPS domain: Create or delete a domain using the
eaps domain command (section 7.16.1 on page 826). The domain name
is used as the index for this domain in the EAPS database. When deleting
an EAPS Domain, first release the Control VLAN (CVLAN) and Protected
VLANs configured on this domain (as described in step 5 and 6 below). If a
port on the domain ring has not been added to another domain ring, this port
will be reset to operate as a normal port. The database of this domain will
then be cleared.
2. Define the EAPS mode of the ECN330-switch: After creating an EAPS
domain, define the EAPS mode for this node using the mode command
Command Function Mode Page
eaps domain Creates an EAPS domain GC 826
mode Configures master node or transit node EAPS 827
hellotime Sets the interval at which to send health-check
packets
EAPS 828
failtime Sets the time to wait for a health-check packet EAPS 829
port Sets port type on ring as primary or secondary EAPS 830
control-vlan Adds a Control VLAN to an EAPS domain EAPS 831
protect-vlan Adds a Protected VLAN to an EAPS domain EAPS 833
enable Activates an EAPS domain EAPS 834
eaps Enables EAPS on the ECN330-switch GC 835
show eaps Displays status information for configured EAPS
domains
PE 836
To Next Page
Loading...
Need help?
General
