Command Line Interface
10191553-KDU 137 365 Uen D 2006-06-16
Example
The following example defines a default gateway for the ECN330-switch:
Related Commands
show ip redirects (section 7.25.4 on page 1020)
ip routing (section 7.26.1 on page 1029)
ip route (section 7.26.2 on page 1030)
7.25.3 show ip interface
This command displays the settings of an IP interface.
Default Setting
All interfaces
Command Mode
Privileged Exec
Example
Console(config)#ip default-gateway 10.1.0.254
Console(config)#
Console#show ip interface
Vlan 1 is up, addressing mode is User
Management VLAN is enabled.
Interface address is 192.168.1.2, mask is 255.255.255.0, Primary
MTU is 1500 bytes
Proxy ARP is disabled
Split horizon is enabled
Vlan 246 is up, addressing mode is DHCP
MTU is 1500 bytes
Proxy ARP is disabled
Split horizon is disabled
Console#
To Next Page
Loading...
