Command Line Interface
628 1553-KDU 137 365 Uen D 2006-06-16
7.6.14 snmp-server user
This command adds a user to an SNMP group, restricting the user to a specific
SNMP Read, Write, or Notify View. Use the no form to remove a user from an
SNMP group.
Syntax
snmp-server user <username> <groupname> [remote <ip-
address>] {v1 | v2c | v3 [encrypted] [auth {md5 |
sha} <auth-password> [priv des56 <priv-password>]]
no snmp-server user <username> {v1 | v2c | v3 | remote}
• username - Name of user connecting to the SNMP agent.
(Range: 1-32 characters)
• groupname - Name of an SNMP group to which the user is
assigned. (Range: 1-32 characters)
• remote - Specifies an SNMP engine on a remote device.
• ip-address - The Internet address of the remote device.
• v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
• encrypted - Accepts the password as encrypted input.
• auth - Uses SNMPv3 with authentication.
• md5 | sha - Uses MD5 or SHA authentication.
• auth-password - Authentication password. Enter as plain text if
the encrypted option is not used. Otherwise, enter an encrypted
password. (A minimum of eight characters is required.)
• priv des56 - Uses SNMPv3 with privacy with DES56 encryption.
notifyview The associated notify view.
storage-type The storage type for this entry.
Row Status The row status of this entry.
Field Description
To Next Page
Loading...
