Command Line Interface
996 1553-KDU 137 365 Uen D 2006-06-16
Command Mode
Privileged Exec
Command Usage
•An address specifies the client’s IP address. If an asterisk (*) is used
as the address parameter, the DHCP server clears all automatic
bindings.
• Use the no host command to delete a manual binding.
• This command is normally used after modifying the address pool, or
after moving DHCP service to another device.
Example
.
Related Commands
show ip dhcp binding (section 7.23.21 on page 996)
7.23.21 show ip dhcp binding
This command displays address bindings on the DHCP server.
Syntax
show ip dhcp binding [address]
address - Specifies the IP address of the DHCP client for which
bindings will be displayed.
Default Setting
None
Console#clear ip dhcp binding *
Console#
To Next Page
Loading...
