Command Line Interface
9951553-KDU 137 365 Uen D 2006-06-16
Default Setting
If no type is specified, the default protocol is Ethernet.
Command Mode
DHCP Pool Configuration
Command Usage
This command identifies a DHCP or BOOTP client to bind to an address
specified in the host command. BOOTP clients cannot transmit a client
identifier. To bind an address to a BOOTP client, a hardware address must
be associated with the host entry.
Example
Related Commands
host (section 7.23.17 on page 992)
7.23.20 clear ip dhcp binding
This command deletes an automatic address binding from the DHCP server
database.
Syntax
clear ip dhcp binding {address | * }
• address - The address of the binding to clear.
• * - Clears all automatic bindings.
Default Setting
None
Console(config-dhcp)#hardware-address 00-e0-29-94-34-28 ethernet
Console(config-dhcp)#
To Next Page
Loading...
