Command Line Interface
994 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
• This command identifies a DHCP client to bind to an address specified
in the host command. If both a client identifier and hardware address
are configured for a host address, the client identifier takes precedence
over the hardware address in the search procedure.
• BOOTP clients cannot transmit a client identifier. To bind an address to
a BOOTP client, a hardware address must be associated with the host
entry.
Example
Related Commands
host (section 7.23.17 on page 992)
7.23.19 hardware-address
This command specifies the hardware address of a DHCP client. This command
is valid for manual bindings only. Use the no form to remove the hardware
address.
Syntax
hardware-address <hardware-address> <type>
no hardware-address
• hardware-address - Specifies the MAC address of the client
device.
• type - Indicates the following protocol used on the client device:
• ethernet
• ieee802
• fddi
Console(config-dhcp)#client-identifier text steve
Console(config-dhcp)#
To Next Page
Loading...
