Ericsson ECN330 - Setting Broadcast Storm Thresholds

Configuring the ECN330-switch
2071553-KDU 137 365 Uen D 2006-06-16
CLI – The following example displays the LACP configuration settings and
operational state for the remote side of port channel 1.
6.7.4 Setting Broadcast Storm Thresholds
Broadcast storms may occur when a device on the network is malfunctioning, or
if application programs are not well designed or properly configured. If there is
too much broadcast traffic on the network, performance can be severely
degraded or everything can come to complete halt.
The network can be protected from broadcast storms by setting a threshold for
broadcast traffic for each port. Any broadcast packets exceeding the specified
threshold will then be dropped.
Command Usage
• Broadcast Storm Control is enabled by default.
• Broadcast control does not effect IP multicast traffic.
Console#show lacp 1 neighbors
Port channel 1 neighbors
--------------------------------------------------------------------
Eth 1/2
--------------------------------------------------------------------
Partner Admin System ID: 32768, 00-00-00-00-00-00
Partner Oper System ID: 32768, 00-01-F4-78-AE-C0
Partner Admin Port Number: 2
Partner Oper Port Number: 2
Port Admin Priority: 32768
Port Oper Priority: 32768
Admin Key: 0
Oper Key: 3
Admin State: defaulted, distributing, collecting,
synchronization, long timeout,
Oper State: distributing, collecting,
synchronization, aggregation,
long timeout, LACP-activity
.
.
.