Command Line Interface
5571553-KDU 137 365 Uen D 2006-06-16
System SBC Mode Commands
This section describes commands used to enable or disable the SBC and test
the SBC LED.
Table 39 SBC Commands
7.5.12 sbc power
This command enable or disables the Single Board Computer (SBC) connected
to port 28. Use the no form to turn off the SBC.
Syntax
[no] sbc power
Default Setting
Enabled (ECN330 Mode)
Command Mode
Global Configuration
Command Usage
• Use the sbc power command to turn on the SBC and toggle the
console interface to SBC display mode. When the SBC is enabled, the
SBC provides a management proxy functionality, where management of
embedded nodes including the ECN330-switch is done by the SBC
which is managed by PEM. Note that when the SBC is enabled, the
console interface is set to SBC display mode.
Command Function Mode Page
sbc power Enable or disables the SBC GC 557
sbc ctrlled Test the SBC LED GC 559
To Next Page
Loading...
