Ericsson ECN330 - Ip Igmp Snooping Query-Count

Command Line Interface
944 1553-KDU 137 365 Uen D 2006-06-16
7.21.8 ip igmp snooping query-count
This command configures the query count. Use the no form to restore the
default.
Syntax
ip igmp snooping query-count <count>
no ip igmp snooping query-count
count - The maximum number of queries issued for which there has
been no response before the ECN330-switch takes action to drop a
client from the multicast group. (Range: 1-10)
Default Setting
2 times
Command Mode
Global Configuration
Command Usage
The query count defines how long the querier waits for a response from a
multicast client before taking action. If a querier has sent a number of
queries defined by this command, but a client has not responded, a
countdown timer is started using the time defined by ip igmp snooping
query-max-response-time. If the countdown finishes, and the client still
has not responded, then that client is considered to have left the multicast
group.
Example
The following shows how to configure the query count to 10:
Console(config)#ip igmp snooping query-count 10
Console(config)#