Command Line Interface
540 1553-KDU 137 365 Uen D 2006-06-16
7.5 System Management Commands
These commands are used to control system logs, passwords, user names,
management options, and display or configure a variety of other system
information.
Table 34 System Management Commands
Command Group Function Page
Device Designation Configures information that uniquely identifies the
ECN330-switch
541
System Status Displays system configuration, active managers, and
version information
542
System Mode Configures the ECN330-switch to operate in normal mode,
QinQ mode, or L2MPLS mode
551
System MTU Enables support for jumbo frames; sets the maximum
transfer unit size
554
System SBC Mode Enables the SBC board; tests the SBC LED 557
File Management Manages code image or ECN330-switch configuration files 560
Line Sets communication parameters for the serial port,
including baud rate and console time-out
569
Event Logging Controls logging of error messages 584
SMTP Alerts Configures SMTP email alerts 594
Time (System Clock) Sets the system clock automatically through an NTP/SNTP
server or manually
600
To Next Page
Loading...
