Command Line Interface
9791553-KDU 137 365 Uen D 2006-06-16
7.23.4 ip dhcp relay server
This command specifies the addresses of DHCP servers to be used by the
ECN330-switch’s DHCP relay agent. Use the no form to clear all addresses.
Syntax
ip dhcp relay server <address1> [address2 [address3
...]]
no ip dhcp relay server
address - IP address of DHCP server. (Range: 1-3 addresses)
Default Setting
None
Command Mode
Interface Configuration (VLAN)
Command Usage
• The IP address for at least one DHCP server must be specified.
Otherwise, the ECN330-switch’s DHCP relay agent will not forward
client requests to a DHCP server.
• To start DHCP relay service, enter the ip dhcp restart relay
command.
Example
Related Commands
ip dhcp restart relay (section 7.23.3 on page 977)
Console(config)#interface vlan 1
Console(config-if)#ip dhcp relay server 10.1.0.99
Console(config-if)#
To Next Page
Loading...
