Command Line Interface
946 1553-KDU 137 365 Uen D 2006-06-16
7.21.10 ip igmp snooping query-max-response-time
This command configures the snooping report delay. Use the no form of this
command to restore the default.
Syntax
ip igmp snooping query-max-response-time
<tenths_of_second>
no ip igmp snooping query-max-response-time
tenths_of_second - The report delay advertised in IGMP queries.
(Range: 1-255)
Default Setting
10 seconds
Command Mode
Global Configuration
Command Usage
• The ECN330-switch must be using IGMPv2 or v3 snooping for this
command to take effect.
• This command defines the time after a query, during which a response
is expected from a multicast client. If a querier has sent a number of
queries defined by the ip igmp snooping query-count, but a
client has not responded, a countdown timer is started using an initial
value set by this command. If the countdown finishes, and the client still
has not responded, then that client is considered to have left the
multicast group.
To Next Page
Loading...
