Ericsson ECN330 - Spanning Tree Algorithm Commands

Command Line Interface
794 1553-KDU 137 365 Uen D 2006-06-16
7.15 Spanning Tree Algorithm Commands
This section includes commands that configure the Spanning Tree Algorithm
(STA) globally for the ECN330-switch, and commands that configure STA for the
selected interface.
Table 85 Spanning Tree Commands
Command Function Mode Page
spanning-tree Enables the spanning tree protocol GC 796
spanning-tree
mode
Configures STP, RSTP, or MSTP mode GC 797
spanning-tree
forward-time
Configures the spanning tree bridge forward time GC 799
spanning-tree
hello-time
Configures the spanning tree bridge hello time GC 800
spanning-tree
max-age
Configures the spanning tree bridge maximum
age
GC 801
spanning-tree
priority
Configures the spanning tree bridge priority GC 802
spanning-tree
pathcost method
Configures the path cost method for RSTP/MSTP GC 803
spanning-tree
transmission-
limit
Configures the transmission limit for RSTP/
MSTP
GC 804
spanning-tree
mst-configuration
Changes to MSTP configuration mode GC 804
mst vlan Adds VLANs to a spanning tree instance MST 805
mst priority Configures the priority of a spanning tree
instance
MST 806