Command Line Interface
10811553-KDU 137 365 Uen D 2006-06-16
Example
7.26.39 ip ospf retransmit-interval
This command specifies the time between resending link-state advertisements
(LSAs). Use the no form to restore the default value.
Syntax
ip ospf retransmit-interval <seconds>
no ip ospf retransmit-interval
seconds - Sets the interval at which LSAs are retransmitted from this
interface. (Range: 1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
5 seconds
Command Usage
A router will resend an LSA to a neighbor if it receives no acknowledgment.
The retransmit interval should be set to a conservative value that provides
an adequate flow of routing information, but does not produce unnecessary
protocol traffic. Note that this value should be larger for virtual links.
Example
Console(config)#interface vlan 1
Console(config-if)#ip ospf priority 5
Console(config-if)#
Console(config)#interface vlan 1
Console(config-if)#ip ospf retransmit-interval 7
Console(config-if)#
To Next Page
Loading...
