Command Line Interface
584 1553-KDU 137 365 Uen D 2006-06-16
Event Logging Commands
This section describes commands used to configure event logging on the
ECN330-switch.
Table 43 Event Logging Commands
7.5.32 logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Function Mode Page
logging on Controls logging of error messages GC 584
logging history Limits syslog messages saved to switch memory
based on severity
GC 585
logging host Adds syslog server host IP addresses that will
receive logging messages
GC 587
logging
facility
Sets the facility type for remote logging of syslog
messages
GC 588
logging trap Limits syslog messages saved to a remote server
based on severity
GC 589
clear logging Clears messages from the logging buffer PE 590
show logging Displays the state of logging PE 591
show log Displays log messages PE 593
To Next Page
Loading...
