Command Line Interface
5851553-KDU 137 365 Uen D 2006-06-16
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. The logging history command controls
the type of error messages that are stored in memory. The logging trap
command controls the type of error messages that are sent to specified
syslog servers.
Example
Related Commands
logging history (section 7.5.33 on page 585)
logging trap (section 7.5.36 on page 589)
clear log (section 7.5.37 on page 590)
7.5.33 logging history
This command limits syslog messages saved to switch memory based on
severity. The no form returns the logging of syslog messages to the default level.
Syntax
logging history {flash | ram} <level>
no logging history {flash | ram}
• flash - Event history stored in flash memory (permanent memory).
• ram - Event history stored in temporary RAM (memory flushed on
power reset).
• level - One of the levels listed in the following table. Messages
sent include the selected level down to level 0. (Range:0-7)
Console(config)#logging on
Console(config)#
To Next Page
Loading...
