Command Line Interface
8471553-KDU 137 365 Uen D 2006-06-16
• Timer values must meet the following restrictions:
• leave >= (2 x join)
• leaveall > leave
Note: Set GVRP timers on all Layer 2 devices connected in the same
network to the same values. Otherwise, GVRP may not operate successfully.
Example
Related Commands
show garp timer (section 7.17.1.6 on page 847)
7.17.1.6 show garp timer
This command shows the GARP timers for the selected interface.
Syntax
show garp timer [interface]
interface
• ethernet <unit>/<port>
• unit - This is device 1.
• port - Physical port number on the ECN330
(Range: 1-28).
• port-channel <channel-id> - The assigned number of an
aggregated link (Range: 1-13)
Default Setting
Shows all GARP timers.
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
To Next Page
Loading...
