Command Line Interface
736 1553-KDU 137 365 Uen D 2006-06-16
7.9 Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
Table 72 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface
configuration mode
GC 737
description Adds a description to an interface configuration IC 738
speed-duplex Configures the speed and duplex operation of a given
interface when autonegotiation is disabled
IC 739
negotiation Enables autonegotiation of a given interface IC 740
capabilities Advertises the capabilities of a given interface for use
in autonegotiation
IC 741
flowcontrol Enables flow control on a given interface IC 743
media-type Force port type selected for combination ports IC 745
shutdown Disables an interface IC 746
switchport
broadcast
packet-rate
Configures broadcast storm control IC 747
clear
counters
Clears the statistics on a given interface PE 748
show
interfaces
status
Displays status for the specified interface NE,
PE
749
To Next Page
Loading...
