Ericsson ECN330 - Configuration Commands

Command Line Interface
5231553-KDU 137 365 Uen D 2006-06-16
To enter Privileged Exec mode, enter the following commands and passwords:
7.2.10 Configuration Commands
Configuration commands are privileged level commands used to modify
ECN330-switch settings. These commands modify the running configuration
only and are not saved when the ECN330-switch is rebooted. To store the
running configuration in nonvolatile storage, use the copy running-config
startup-config command.
The configuration commands are organized into different modes:
• Global Configuration - These commands modify the system level
configuration, and include commands such as hostname and snmp-
server community.
• Access Control List Configuration - These commands are used for
packet filtering.
• Class Map Configuration - Creates a DiffServ class map for a specified
traffic type.
• DHCP Configuration - These commands are used to configure the
DHCP server.
Username: admin
Password: [system login password]
CLI session with the Embedded Switching/Routing Unit is opened.
To end the CLI session, enter [Exit].
Console#
Username: [Normal Exec user name]
Password: [system login password]
CLI session with the Embedded Switching/Routing Unit is opened.
To end the CLI session, enter [Exit].
Console>
Console>enable
Password: [privileged level password]
Console#