Command Line Interface
6031553-KDU 137 365 Uen D 2006-06-16
Command Usage
This command specifies time servers from which the ECN330-switch will
poll for time updates when set to SNTP client mode. The client will poll the
time servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set through the sntp poll
command.
Example
Related Commands
sntp client (section 7.5.46 on page 601)
sntp poll (section 7.5.48 on page 603)
show sntp (section 7.5.49 on page 604)
7.5.48 sntp poll
This command sets the interval between sending time requests when the
ECN330-switch is set to SNTP client mode. Use the no form to restore to the
default.
Syntax
sntp poll <seconds>
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Console(config)#sntp server 10.1.0.19
Console#
To Next Page
Loading...
