Ericsson ECN330 - Snmp-Server Enable Traps

Command Line Interface
618 1553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
snmp-server enable traps (section 7.6.7 on page 618)
7.6.7 snmp-server enable traps
This command enables the ECN330-switch to send SNMP traps or informs (that
is, SNMP notifications). Use the no form to disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-
down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If an snmp-server enable traps command is not entered, no
notifications controlled by this command are sent. To configure the
ECN330-switch to send SNMP notifications, enter at least one snmp-
server enable traps command. If the command is entered with no
keywords, both authentication and link-up-down notifications are
enabled. If the command is entered with a keyword, only the notification
type related to that keyword is enabled.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#