Command Line Interface
542 1553-KDU 137 365 Uen D 2006-06-16
Example
System Status Commands
This section describes commands used to display system information.
Table 36 System Status Commands
7.5.2 show startup-config
This command displays the configuration file stored in non-volatile memory that
is used to start up the system.
Default Setting
None
Console(config)#hostname -Copenhagen-Site1
Console(config)#
Command Function Mode Page
show startup-
config
Displays the contents of the configuration file (stored
in flash memory) that is used to start up the system
PE 542
show running-
config
Displays the configuration data currently in use PE 545
show system Displays system information NE,
PE
548
show users Shows all active console and Telnet sessions,
including user name, idle time, and IP address of
Telnet client
NE,
PE
549
show version Displays version information for the system NE,
PE
550
To Next Page
Loading...
