Command Line Interface
1146 1553-KDU 137 365 Uen D 2006-06-16
7.27.33 ip pim register-rate-limit
This command configures the rate at which register messages are sent by the
Designated Router (DR) for each (source, group) entry. Use the no form to
restore the default setting.
Syntax
ip pim register-rate-limit <rate>
no pim register-rate-limit
rate - The maximum number of register packets per second.
(Range: 1-65535: Default: 0, which means no limit)
Default Setting
no limit
Command Mode
Global Configuration
Command Usage
This command can be used to relieve the load on the Designated Router
(DR) and RP. However, because register messages exceeding the limit are
dropped, some receivers may experience data packet loss within the first
few seconds in which register messages are sent from bursty sources.
To Next Page
Loading...
