Command Line Interface
612 1553-KDU 137 365 Uen D 2006-06-16
7.6.3 snmp-server community
This command defines the SNMP v1 and v2c community access strings. Use
the no form to remove the specified community string.
Syntax
snmp-server community <string> [ro | rw]
no snmp-server community <string>
• string - Community string that acts like a password and permits
access to the SNMP protocol. (Maximum length: 32 characters,
case sensitive; Maximum number of strings: 5)
• ro - Specifies read-only access. Authorized management stations
are only able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management stations
are able to both retrieve and modify MIB objects.
Default Setting
• public - Read-only access. Authorized management stations are only
able to retrieve MIB objects.
• private - Read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
Command Mode
Global Configuration
Example
Console(config)#snmp-server community alpha rw
Console(config)#
To Next Page
Loading...
