Command Line Interface
7071553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
ip access-group (section 7.8.8 on page 705)
MAC ACLs
The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access
list containing the required permit or deny rules, set a precedence mask to
control the filter sequence, and then bind the access list to one or more ports
Table 69 MAC ACL Commands
Console#show ip access-group
Interface ethernet 1/2
IP standard access-list david
Console#
Command Function Mode Page
access-list mac Creates a MAC ACL and enters configuration
mode
GC 708
permit, deny Filters packets matching a specified source and
destination address, packet format, and Ethernet
type
MAC-
ACL
709
show mac
access-list
Displays the rules for configured MAC ACLs PE 711
access-list mac
mask-precedence
Changes to the mode for configuring access
control masks
GC 712
mask Sets a precedence mask for the ACL rules MAC-
Mask
713
show access-
list mac mask-
precedence
Shows the ingress or egress rule masks for MAC
ACLs
PE 716
To Next Page
Loading...
