Command Line Interface
708 1553-KDU 137 365 Uen D 2006-06-16
7.8.10 access-list mac
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
Syntax
[no] access-list mac <acl_name>
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When a new ACL is created or configuration mode for an existing ACL
entered, use the permit or deny command to add new rules to the
bottom of the list. To create an ACL, add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed
by the exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
mac access-
group
Adds a port to a MAC ACL IC 717
show mac
access-group
Shows port assignments for MAC ACLs PE 718
Command Function Mode Page
To Next Page
Loading...
