Ericsson ECN330 - Timeout Login Response

Command Line Interface
574 1553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
login (section 7.5.20 on page 571)
password-thresh (section 7.5.24 on page 576)
7.5.22 timeout login response
This command sets the interval that the system waits for a user to log into the
CLI. Use the no form to restore the default setting.
Syntax
timeout login response [seconds]
no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 0 - 300 seconds; 0: disabled)
Default Setting
CLI: Disabled (0 seconds)
Telnet: 300 seconds
Command Mode
Line Configuration
Command Usage
• If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
• This command applies to both the local console and Telnet connections.
• The timeout for Telnet cannot be disabled.
Console(config-line)#password 0 secret
Console(config-line)#