Command Line Interface
8571553-KDU 137 365 Uen D 2006-06-16
7.17.6 switchport mode
This command configures the VLAN membership mode for a port. Use the no
form to restore the default.
Syntax
switchport mode {hybrid | trunk | private-vlan |
dot1q-tunnel}
no switchport mode
• hybrid - Specifies a hybrid VLAN interface. The port may transmit
tagged or untagged frames.
• trunk - Specifies a port as an end-point for a VLAN trunk. A trunk
is a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN. However, note that frames
belonging to the port’s default VLAN (that is, associated with the
PVID) are also transmitted as tagged frames.
• private-vlan - For an explanation of this command see section
7.17.18 on page 873.
• dot1q-tunnel - For an explanation of this command see section
on page 882.
Default Setting
All ports are in hybrid mode.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following shows how to set the configuration mode to port 1, and then set
the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
To Next Page
Loading...
