Command Line Interface
1016 1553-KDU 137 365 Uen D 2006-06-16
7.25.1 ip address
This command sets the IP address for the currently selected VLAN interface.
Use the no form to restore the default IP address.
Syntax
ip address {<ip-address> <netmask> | bootp | dhcp}
[secondary]
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
• secondary - Specifies a secondary IP address.
Default Setting
DHCP
Command Mode
Interface Configuration (VLAN)
show ip
redirects
Displays the default gateway configured for the
ECN330-switch
PE 1020
ping Sends ICMP echo request packets to another node
on the network
NE, PE 1021
Command Function Mode Page
To Next Page
Loading...
