Command Line Interface
6131553-KDU 137 365 Uen D 2006-06-16
7.6.4 snmp-server contact
This command sets the system contact string. Use the no form to remove the
system contact information.
Syntax
snmp-server contact <string>
no snmp-server contact
string - String that describes the system contact information.
(Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server location (section 7.6.5 on page 614)
Console(config)#snmp-server contact Paul
Console(config)#
To Next Page
Loading...
