Ericsson ECN330 - Spanning-Tree Mode

Command Line Interface
7971553-KDU 137 365 Uen D 2006-06-16
Example
This example shows how to enable the Spanning Tree Algorithm for the
ECN330-switch:
7.15.2 spanning-tree mode
This command selects the spanning tree mode for the ECN330-switch. Use the
no form to restore the default.
Syntax
spanning-tree mode {stp | rstp | mstp}
no spanning-tree mode
• stp - Spanning Tree Protocol (IEEE 802.1D)
• rstp - Rapid Spanning Tree Protocol (IEEE 802.1w)
• mstp - Multiple Spanning Tree Protocol (IEEE 802.1s)
Default Setting
RSTP
Command Mode
Global Configuration
Command Usage
• Spanning Tree Protocol
Uses RSTP for the internal state machine, but sends only 802.1D
BPDUs.
• This creates one spanning tree instance for the entire network. If
multiple VLANs are implemented on a network, the path between
specific VLAN members may be inadvertently disabled to prevent
Console(config)#spanning-tree
Console(config)#