Command Line Interface
796 1553-KDU 137 365 Uen D 2006-06-16
7.15.1 spanning-tree
This command enables the Spanning Tree Algorithm globally for the ECN330-
switch. Use the no form to disable it.
Syntax
[no] spanning-tree
Default Setting
Spanning tree is disabled.
Command Mode
Global Configuration
Command Usage
The Spanning Tree Algorithm (STA) can be used to detect and disable
network loops, and to provide backup links between switches, bridges or
routers. This allows the ECN330-switch to interact with other bridging
devices (that is, an STA-compliant switch, bridge or router) in the network to
ensure that only one route exists between any two stations on the network,
and provide backup links which automatically take over when a primary link
goes down.
show spanning-
tree
Shows spanning tree configuration for the overall
bridge or a selected interface
PE 821
show spanning-
tree mst
configuration
Shows the multiple spanning tree configuration PE 823
Command Function Mode Page
To Next Page
Loading...
