Ericsson ECN330 - Ip Pim Register-Checksum-Withdata

Command Line Interface
11531553-KDU 137 365 Uen D 2006-06-16
7.27.38 ip pim register-checksum-withdata
This command calculates the register checksum over the whole packet instead
of just the packet header. Use the no form to restore the default setting.
Syntax
[no] ip pim register-checksum-withdata
Default Setting
Disabled - Register checksum is calculated only over the header.
Command Mode
Global Configuration
Example
This example makes the ECN330-switch calculate the register checksum over
the whole packet.
Related Commands
show ip pim (section 7.27.44 on page 1161)
Console(config)#ip pim register-checksum-withdata
Console(config)#exit
Console#show ip pim
PIM-DM Admin Status: Disabled
PIM-SM Admin Status: Enabled
Join/Prune-Interval: 60
Register-Suppression: 500
Register-Rate-Limit: 500
Register-CheckSum-with Data: Enabled
Ignore RP-Set-Priority: Enabled
CRP-Prefix: Enabled
SPT-Threshold: Enabled
SPT-Threshold Group: 224.1.0.0
SPT-Threshold Group mask: 255.255.0.0
Console#