Command Line Interface
1152 1553-KDU 137 365 Uen D 2006-06-16
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Cisco's BSR does not conform to the latest BSR draft. It does not accept
candidate RPs with a group prefix of zero. This command is therefore
required to make the ECN330-switch an acceptable candidate RP for a
Cisco BSR.
Example
This example makes the ECN330-switch an acceptable RP candidate for Cisco
BSRs.
Related Commands
show ip pim (section 7.27.44 on page 1161)
Console(config)#ip pim crp-prefix
Console(config)#exit
Console#show ip pim
PIM-DM Admin Status: Disabled
PIM-SM Admin Status: Enabled
Join/Prune-Interval: 60
Register-Suppression: 500
Register-Rate-Limit: 500
Register-CheckSum-with Data: Disabled
Ignore RP-Set-Priority: Enabled
CRP-Prefix: Enabled
SPT-Threshold: Enabled
SPT-Threshold Group: 224.1.0.0
SPT-Threshold Group mask: 255.255.0.0
Console#
To Next Page
Loading...
