Command Line Interface
6291553-KDU 137 365 Uen D 2006-06-16
• priv-password - Privacy password. Enter as plain text if the
encrypted option is not used. Otherwise, enter an encrypted
password.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The SNMP engine ID is used to compute the authentication/privacy
digests from the password. Therefore, configure the engine ID with the
snmp-server engine-id command (section 7.6.8 on page 619)
before using this configuration command.
• Before configuring a remote user, use the snmp-server engine-id
command to specify the engine ID for the remote device where the user
resides. Then use the snmp-server user command to specify the
user and the IP address for the remote device where the user resides.
The remote agent’s SNMP engine ID is used to compute authentication/
privacy
digests from the user’s password. If the remote engine ID is not
first configured,
the snmp-server user command specifying a
remote user will fail.
• SNMP passwords are localized using the engine ID of the authoritative
agent. For informs, the authoritative SNMP agent is the remote agent.
Therefore, configure the remote agent’s SNMP engine ID before
sending proxy requests or informs to it.
Example
Console(config)#snmp-server user steve group r&d v3 auth md5
greenpeace priv des56 einstien
Console(config)#snmp-server user mark group r&d remote 192.168.1.19
v3 auth md5 greenpeace priv des56 einstien
Console(config)#
To Next Page
Loading...
