Command Line Interface
842 1553-KDU 137 365 Uen D 2006-06-16
7.17.1 GVRP and Bridge Extension Commands
GARP VLAN Registration Protocol defines a way for switches to exchange
VLAN information in order to automatically register VLAN members on
interfaces across the network. This section describes how to enable GVRP for
individual interfaces and globally for the , as well as how to display default
configuration settings for the Bridge Extension MIB.
Caution!
GVRP is included for future use only. It is recommended not to use GVRP in the
EDA system.
Table 90 GVRP and Bridge Extension Commands
Command Function Mode Page
bridge-ext gvrp Enables GVRP globally for the ECN330-
switch
GC 843
show bridge-ext Shows the global bridge extension
configuration
PE 843
switchport gvrp Enables GVRP for an interface IC 844
switchport
forbidden vlan
Configures forbidden VLANs for an interface IC 863
show gvrp
configuration
Displays GVRP configuration for selected
interface
NE, PE 845
garp timer Sets the GARP timer for the selected function IC 846
show garp timer Shows the GARP timer for the selected
function
NE, PE 847
To Next Page
Loading...
