Configuring the ECN330-switch
194 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
• To avoid creating a loop in the network, be sure to enable LACP before
connecting the ports, and also disconnect the ports before disabling
LACP.
• If the target switch has also enabled LACP on the connected ports, the
trunk will be activated automatically.
• A trunk formed with another switch using LACP will automatically be
assigned the next available trunk ID.
• If more than eight ports attached to the same target switch have LACP
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
• All ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.
• Trunks dynamically established through LACP will also be shown in the
Member List on the Trunk Membership menu (see page 191).
Command Attributes
• Current (Member List) – Shows configured trunks (Unit, Port).
• New – Selects a port to add to the current LACP-enabled port list.
• Port – Port identifier. (Range: 1-28)
To Next Page
Loading...
