Configuring the ECN330-switch
192 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
• When configuring static trunks, switches of different types may not be
able to link, depending on the manufacturer’s implementation. However,
note that the static trunks on the ECN330-switch are Cisco
EtherChannel compatible.
• To avoid creating a loop in the network, add a static trunk through the
configuration interface before connecting the ports, and also disconnect
the ports before removing a static trunk through the configuration
interface.
Command Attributes
• Current (Member List) – Shows configured trunks (Trunk ID, Unit,
Port).
• New – Includes entry fields for creating new trunks.
• Trunk – Trunk identifier. (Range: 1-13)
• Port – Port identifier. (Range: 1-28)
Web – Click Trunk, Trunk Membership. Enter a trunk ID of 1-13 in the Trunk field,
select any of the ECN330-switch ports from the scroll-down port list, and click
Add. After adding the ports to the member list, click Apply.
Figure 71 Static Trunk Configuration
To Next Page
Loading...
